Эта страница не доступна в выбранном языке.
bt 712 – Bench top crimping press
Introduction
The bt 712 bench top press is a precise semiautomatic crimping press with great
functionality and big benefits to users, all at good value for the money.
Key features:
- Easy and intuitive controls (TopTouch, TCI)
- High daily output due to ultra-short cycle time and changeovers that take just seconds
- Reliable bad part detection thanks to integrated quality monitoring
- Good value for the money
Function
The semiautomatic bt 712 bench top model is compelling for its modern technology
and sets new standards in quality and speed. This all-purpose press accommodates the use of all common
commercial crimping tools so individual crimps previously done manually can be processed on it with
great precision. In terms of safety features, the bt 712 has a safety cover equipped with a dual-channel
safety system (RCS).
The software (in 12 languages) can be operated from a small touch screen interface
(TCI). The bench top press is also a service tool with a data memory for storing up to 500 articles,
for making backups and for uploading updates.
The crimp force analyzer that comes with the press detects good and bad wires reliably
and gives a detailed description of errors.
Proven and useful options such as short projecting cable, bad contact cutter (BCC),
fine adjustment and a contact strip chopper can all be integrated in the press to boost efficiency and
process quality even more.
Technical data
| Cross section range | bis 6 mm2 (AWG10)* |
|---|---|
| Crimp force | 20 kN (2 tons) |
| Adjustable crimp height | +5.00/-3.00 mm |
| Resolution | 0.01 mm |
| Repeat accuracy | +/-0.01 mm |
| Stroke | programmable 10 – 40 mm |
| Cycle time (crimping) | 0.3 sec |
*Depends
on the crimping tool/with optional short shield length of 23 mm
Accessories/options
- Bad part cutter
- Contact strip chopper (chopper)
- Active paper winder
- Air feed set
- Short shield length
- Table
- Pressure regulation set
- Crimp module analyzer
Optional bad part cutter
The bad part cutter cuts off any crimp detected as bad by the crimp force analyzer.
You can program whether the cut is to go directly through the terminal or through the conductor. Cutting
through the terminal involves less loss of cable length, allowing further use of the conductor.
Services
Komax предлагает оптимальную последующую поддержку оборудования Service offers.
