Hand actuated pulltester can give inconsistent data depending on the operator pull rate. The IEC standard specifies that a pulltester should measure with a consistent pull rate.
Qstat 100 is a motorized bench top pulltester equipped with a PWM speed controller, ensuring consistent pull speed throughout the entire measuring range; a wide spectrum of crimp connections as well as ultrasonic welded connections can be tested using the 12 position standard terminal holder.
Functions
- Multi-language support
- Visualisation of pull force profile
- Job queue status button for browsing of outstanding quality verification job sent by Qpex-CFM
Connectivity
- Through serial communication interface the Qstat 100 allows external micrometer to be connected for crimp height/crimp width measurements. A one stop quality station for wire harnessing shop floor
- Fully integrated with Qpex crimp force monitoring system to retrieve quality validation data of crimp connection specification via LAN/WiFi, to prevent production of wrong specification crimp connection
Software
- SL Qstat PC-Software – matched to your device
Measuring Range |
0 – 1000 N |
Measuring units |
N, Kgf; Lbf |
Speed |
25, 50, 100 mm/min |
Accuracy
|
< 1% of full range
|
Resolution
|
0.1 N
|
Connectivity
|
Mitutoyo micrometer
|
Network
|
RS 232 serial communication
Ethernet LAN/WiFi
|
Power Supply
|
85 × 265 VAC; 50 watt
|
Dimensions (L×W×H)
|
180 × 90 × 360 mm
|
Weight
|
approx. 10 kg |